INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL INTERJECT INTERNATIONAL
 

1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER
Product Name Inter-Ject Fuel Machine Cleaner
Company Name  Inter-Ject International Pty Ltd
Address 3/132 Ross Court. Cleveland. Qld 4163. Australia
Emergency Tel +617 32867799
Telephone +617 32867799
Fax +617 32867733
Email

peter@interject.com.au
Recommended Use Petrol fuel system cleaner
   

2. HAZARDS IDENTIFICATION

Hazard Classification     Classified as hazardous Dangerous Goods under the NOHSC criteria.
Risk Phrase(s)               

R11 Flammable
R36 Irritating to eyes
R67 Vapours may cause drowsiness and dizziness
Safety Phrase(s)             

R24/25 Avoid contact with skin and eyes. Rinse eyes with water and seek medical advice S33 Take precautionary measures against static discharges. Keep away from sources of ignition.
D G Classification         3
Poisons Schedule           5
   

3. COMPOSITION / INFORMATION ON INGREDIENTS
Ingredients 

Name                                   CAS                           Proportion
Isopropyl Alcohol              67-63-0                      60 - 100%
Organic Solvents                                                    10 - 40%
   

4. FIRST AID MEASURES
Inhalation Move victim to fresh air and seek medical treatment
Ingestion   If swallowed, Do not induce vomiting. Keep at rest and Seek medical treatment.   
Skin  Wash off with soap and water. Remove contaminated clothing and launder before reuse.
Eye  Flush eyes with large amounts of water until irritation subsides. Seek medical attention.
Other Information       

For advise in an emergency, contact the Poisons Information Centre (Tel: 13 1126).
   

5. FIRE FIGHTING MEASURES
Extinguishing Media    

Use water spray, water fog or fine spray mist, alcohol foam..
Specific Hazards         

Product is flammable, vapour/air mixtures may ignite explosively. Product should be stored and used in well ventilated area away from naked flames sparks and other sources of ignition.
Hazchem Code

2[Y]E
Precautions with Fire   Fire fighters should wear full protective clothing and self-contained breathing apparatus.
   

6. ACCIDENTAL RELEASE MEASURES
Emergency Procedures

Wear protective clothing to avoid exposure. Extinguish all ignition sources. Contain the spilled liquid with sand or earth. And prevent from escaping to drains and waterways. Dispose of waste according to applicable local regulations.
   

7. HANDLING AND STORAGE
Precautions for Safe Handling

To prevent contact and inhalation, wear appropriate protection. Use only in ventilated area. Do not open near open flame, sources of heat or ignition.
Storage

Store in a cool dry, well ventilated area away from sources of ignition and oxidising agents, out of direct sunlight. Keep container sealed when not in use. 

   

8. EXPOSURE CONTROLS / PERSONAL PROTECTION
National Exposure Standards

The time weighted average concentration for this product is: 983 mg/m3 (400 ppm), which means the highest allowable exposure concentration in an 8 hour day for a 5 day working week. The short term exposure limit is: 1230 mg/m3 (500 ppm), which is the maximum allowable exposure concentration at any time.
Biological Limit Values   None established
Engineering Controls    The use of exhaust ventilation is recommended to control process emissions near the source.
Respiratory Protection 

It is recommended to use a half-face filter mask to protect from over exposure by inhalation.
Eye Protection              

Always wear safety glasses or a face shield.
   

9. PHYSICAL AND CHEMICAL PROPERTIES
Property Unit Of Measurement Typical View
Appearance   Clear, colourless liquid

Boiling Point

°C 82
Flash point °C 12
Density @ 15°C g/ml 0.785
Vapour Pressure @ 20°C kpa 4.3
Explosive Limits (LEL - UEL) % 1.8 – 12.0
Vapour Density @ 20°C kpa >1.00
Autoignition Temperature °C 350
Viscosity @ 20°C  cSt          Not Applicable
Percent Volatiles %  78%
Solubility with Water % w/w 1
   

10. STABILITY AND REACTIVITY
Chemical Stability         Stable under normal conditions of use
Conditions to Avoid       Sources of heat and ignition.
Hazardous Reactions     Stored mixtures with MEK produce explosive peroxides.
Hazardous Decomposition Products

No decomposition products except on burning. See Fire fighting Measures.
   

11. TOXICOLOGICAL INFORMATION
Ingestion

The single lethal dose for humans is approx 250ml,. Symptoms of overexposure include headache, nausea, dizziness, mental depression, distorted perceptions and respiratory depression.
Eye Irritating to eyes and can cause corneal burns.
Skin Irritating to skin, causing dryness and cracking.
Inhalation Irritating to the respiratory tract.
Chronic Effects Prolonged exposure may cause damage to liver and kidney.
Toxicological Information Not available
   

12. ECOLOGICAL INFORMATION
Ecotoxicity No Data available
Mobility Do not discharge to sewer or waterways, highly mobile due to miscibility with water
Persistence/degradability    Not available
   

13. DISPOSAL CONSIDERATIONS
Disposal Methods Disposal of the product must be in accordance with applicable local and national regulations.
   

14. TRANSPORT INFORMATION
UN No                             1219
Shipping Name                 Isopropyl Alcohol
Dg Class 3
Sub Risk None
Pack Group I 1
Hazchem 2[Y ]E
Transport Information

This product is classed as Dangerous Goods Class 3, packing group II. Please consult the Australian Dangerous Goods Code for Transport by Road and rail for information.

                                        
   

15. REGULATORY INFORMATION
Country / Region             Australia
Inventory  AICS
Status

Listed
Poisons Schedule             5
   

16. OTHER INFORMATION
Reasons for Issue           

Upgrade to 16 point MSDS
   

End of MSDS